Educational

Should You Bleed Torch Lines at the End of the Day? Here’s What the Procedures Say:

Short answer: Most published oxy-acetylene shutdown procedures recommend closing both cylinder valves, bleeding the gas from both lines through the torch, and loosening the regulator adjusting screws at the end of each shift. Although leaving the hoses pressurized overnight is common practice, there are valid reasons to support it. However, [...]

By |2026-10-28T21:05:23+00:00October 29, 2026|Educational, Safety|Comments Off on Should You Bleed Torch Lines at the End of the Day? Here’s What the Procedures Say:

Check Valve or Flashback Arrestor? Your Torch Needs Both

Short answer: a check valve stops gas from flowing backward up a hose. A flashback arrestor stops a flame from travelling back through your system. They perform different safety functions, and a check valve is not a substitute for a flashback arrestor. For oxy-fuel systems, both functions need to be [...]

By |2026-08-26T17:11:07+00:00August 26, 2026|Educational, Safety|Comments Off on Check Valve or Flashback Arrestor? Your Torch Needs Both

Oxygen or Acetylene First? How to Shut Off a Cutting Torch Safely

Quick answer: Follow the manual for the torch you own. Most cutting torch manufacturers' official manuals tell you to close the oxygen valve first. Modern Welding, the standard trade school textbook, teaches fuel gas (acetylene) first. Both methods are used safely every day. The bigger risk isn't the order of [...]

By |2026-07-28T18:34:14+00:00July 15, 2026|Educational, Safety|Comments Off on Oxygen or Acetylene First? How to Shut Off a Cutting Torch Safely

Calculating Cost of Injury

Nobody starts a workday expecting someone to get hurt. But across industrial and construction sectors, workplace injuries happen every single day, and the impact hits your bottom line in ways that aren’t always obvious. In this post, we’re answering a question every employer should be able to answer: how much [...]

By |2026-07-15T18:59:49+00:00June 2, 2026|Educational, Safety|Comments Off on Calculating Cost of Injury

What Is Safe-T Torch™

If you work on a site where open-flame torches are part of the job, you already know the risks. Burns, fires, and gas-related accidents happen, not because workers are careless, but because the tools themselves leave too much room for error. That’s exactly the problem the Safe-T Torch™ was built [...]

By |2026-07-15T19:00:39+00:00June 2, 2026|Educational, Safety|Comments Off on What Is Safe-T Torch™
Go to Top